After visiting the Mediterranean twice this past year, Ive come to embrace the ubiquity that is the evil eye symbol and have since integrated it into the jewelry repertoire.
I'm going to do this and I'm going to make a knot and I'd like to make bigger knot with a big tail just in case I need to adjust.
I have plenty of supplies for several projects to come, and the total cost was only 2, making this a very inexpensive project!All you are going to do to make this bracelet is to tie two pairs of knots.But you may want to experiment with other types.Dont take your thumb off the V-fold until I say its.Now your necklace should look something like this: How to Make an, adjustable Sliding Knot Necklace.So youll need a minimum of 24 (61cm) of cord to fit over the head. Then, do the same thing with the other cord.So if you slide it this way to make the loop bigger to put it on and then once you have it on you pull the knots, the sliding knots and it slides down the corner and makes it tighter.Fold an inch of the tip down over the parallel cords.What youll need: 36 of twine mine is cotton, but you could use leather or hemp whatever you like the looks of! Pass it through the loop when you get to the end.Now, take the tail ends and pass then through the loop.And your finished knot should look like this: The other side of the knot should look like this: Now move to the other side of your necklace. Just changing your focal piece will create and entirely different bracelet.
Lay your cords next to each other, and double the pink cord back over itself.
Do the same thing on the other side youll have a double cord on each side.
Im using a pendant that will be attached with a larks head gmail wachtwoord zichtbaar maken knot.And if you want a longer necklace, you can add your additional length measurement to the above equation.Now thread the short tail of your wrapping cord through the loop formed by the V-fold, being careful to thread it above the straight (dark) center cord: Now heres how to tighten and snug up the loop: With one hand, grasp the little tail.So this is how the cord looked, right.So your total cord length will be: (86.3cm).Advertisement, thanks for watching!Youll need: Thread 4 inches of cord through one side of the charm. With 2 cords, it will look like at least 4 wraps.I love adjustable necklaces because youre not limited to always wearing them at the same length.I'm going to make this a little bit bigger so it's going to be about, and I want to have extra, just to pull this tighter.And whether youre superstitious or not, this is a super simple method which can be applied to any connector or charm!
Photo 3: Bring the 2 cord ends over the top of your pendant, and under the fold in your cord.
The excess cord will be trimmed later.
Now, you have a sliding knot bracelet!
Not so tight that you cant slide it along the brown cord, just tight enough that it wont come undone.