As far as I know, these aren't really produced as there isn't a standard for what size and pitch of comb or mechanism, so it may be best to just buy a new one with the desired song.
This turns gears that make the drum with the small pins rotate, plucking the tines of the metal comb as it slowly spins.
From the outside of the box, press the pencil inward at the indentation spot to create a hole for the winding key.
To get started, take the board and stand it on end inside the box.The same kind of cigar box used to make a guitar in Chapter 1 can be used for a DIY music box.Push it all the way back against the side of the box so the springs stick out toward the middle.This will hold it in place.The comb of the Experimental Music Box follows the same basic design as the Thumb Piano earlier in the chapter.N O, p Q, r S, t U, v W, x Y, z Filter by Best Answers, for a standard sized music box, 1/2 to 1 inch (1.25.5 cm) wide cubes would work well.If you want to play the notes separately, place them at different spots around the rod.Repeat with the other springs.
For the first pin, find a screw that is a little bit longer than the distance between albelli kalender maken the rod and the first spring.Test your ideas to see if they work!Koka Nikoladze uses springs, rulers, forks, and other objects as the comb in his music boxes.The teeth on each comb are different lengths and thicknesses, depending on the notes needed for the melody each box plays.Turn the key to tighten a spring, open the lid to release the catch that lets the spring unwind, and gears and flywheels start to move the mechanism at just the right speed.My Experimental Music Box was inspired by Koka Nikoladze of Norway who builds hand-cranked Beat Machinesmusic boxes that use objects like forks and plastic rulers instead of a metal music box comb.To keep the rod from sliding side to side, wrap rubber bands around the ends of the rod just outside the clothespins to make a little ridge as guides.Then lay a pencil (or other rod) so it rests on the sides of the box next to the board.
If by "tune." you mean the key of the song, roux maken then you could if you changed out the metal comb inside.
When youre done, trying plucking or scraping the springs to see if they are tight enough to make a good tone.
Now attach a spring to the coffee stirrer, just above the line.
Make a mark where the screw should go hold a stick straight across from the spring to the rod to help you line them.
Every part of a music box takes artistry and expertise to create.